Send documentation comments to mdsfeedback-doc@cisco.com
1-19
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 1 CLI Overview
Navigating Through CLI Commands
all-initiator-permit
--- 1,20 ----
fcip enable
+ aaa accounting logsize 500
+
+
+
ip default-gateway 172.22.91.1
iscsi authentication none
iscsi enable
! iscsi initiator name junk
iscsi virtual-target name vt
pWWN 21:00:00:04:cf:4c:52:c1
all-initiator-permit
Example 1-8 Displays the Configuration for a Specified Interface
switch# show running interface fc2/9
interface fc2/9
switchport mode E
no shutdown
Note The show running interface command is different from the show interface command.
Example 1-9 Displays the Configuration for all Interfaces in a 16-Port Module
switch# show running interface fc2/10 - 12
interface fc2/10
switchport mode E
no shutdown
interface fc2/11
switchport mode E
no shutdown
interface fc2/12
switchport mode FL
no shutdown
Example 1-10 Displays the Configuration Per VSAN
switch# show runnning vsan 1
Building Configuration ...
zone name m vsan 1
member pwwn 21:00:00:20:37:60:42:5c
member pwwn 21:00:00:20:37:4b:00:a2
zoneset name m vsan 1
member m
zoneset activate name m vsan 1
Saving a Configuration
To save the configuration, enter the copy running-config startup-config command from the EXEC
mode prompt to save the new configuration into nonvolatile storage. Once this command is issued, the
running and the startup copies of the configuration are identical.
Refer to the Cisco MDS 9000 Family CLI Configuration Guide for further information.
To Next Page
Loading...
Need help?
General
