EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1130 background imageLoading...
Page #1130 background image
Send documentation comments to mdsfeedback-doc@cisco.com
22-156
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips stats netsim
Related Commands Command Description
ips netsim enable Enables two Gigabit Ethernet interfaces to operate in the network
simulation mode.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Preview: Manual
Manual16 pages
Preview: Configuration Guide
Configuration Guide344 pages
Preview: Troubleshooting Guide
Troubleshooting Guide161 pages
Preview: Rack Installation
Rack Installation8 pages
Preview: Installing
Installing22 pages
Preview: Hardware Installation Guide
Hardware Installation Guide62 pages
Preview: Installation Guide
Installation Guide20 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals