Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
23-46
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tlport alpa-cache
tlport alpa-cache
To manually configure entries in an ALPA cache, use the tlport alpa-cache command
tlport alpa-cache interface interface pwwn pwwn alpa alpa
no tlport alpa-cache interface interface pwwn pwwn
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines Generally, ALPA cache entries are automatically populated when an ALPA is assigned to a device. Use
this command only if you wish to manually add further entries.
Examples The following example configures the specified pWWN as a new entry in this cache
switch# config terminal
switch(config)# tlport alpa-cache interface fc1/2 pwwn 22:00:00:20:37:46:09:bd alpa 0x02
Related Commands
interface interface Specifies a Fibre Channel interface.
pwwn pwwn Specifies the peer WWN ID for the ALPA cache entry.
alpa alpa Specifies the ALPA cache to which this entry is to be added.
Release Modification
1.3(5) This command was introduced.
Command Description
show tlport Displays TL port information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available