EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1113 background imageLoading...
Page #1113 background image
Send documentation comments to mdsfeedback-doc@cisco.com
22-139
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ip arp
show ip arp
To display IP neighbors for the system, use the show ip arp command.
show ip arp [interface {cpp module-number | gigabitethernet slot/port | mgmt | vsan vsan-id}]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays IP neighbor information.
switch# show ip arp
IP Address Age(min) Link-layer Addr Type Interface
10.10.10.100 0 0006.d623.4008 ARPA GigabitEthernet1/1
10.10.10.9 5 0002.b3d9.ba6f ARPA GigabitEthernet1/1
10.10.10.16 11 0004.23bd.677b ARPA GigabitEthernet1/1
172.22.31.1 67 0000.0c07.ac01 ARPA mgmt0
172.22.31.2 0 000e.d68f.c3fc ARPA mgmt0
172.22.31.3 0 000e.d68f.43fc ARPA mgmt0
172.22.31.250 1067 00e0.8152.7f8d ARPA mgmt0
Related Commands
interface Displays the IP neighbors for a specified interface.
cpp module-number Specifies the virtualization IP over Fibre Channel (IPFC) interface by
control plane processor (CPP) module number. The range is 1 to 6.
gigabitethernet slot/port Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
mgmt Specifies the management interface.
vsan vsan-id Specifies the IPFC VSAN interface by VSAN ID. The range is 1 to 4093.
Release Modification
3.0(1) This command was introduced.
Command Description
show ip interface Displays IP interface status and configuration information.
show ip traffic Displays IP protocol statistics for the system.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals