Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-138
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr withdraw domain
ivr withdraw domain
To withdraw overlapping virtual domain from a specified VSAN, use the ivr withdraw domain
command in EXEC mode.
ivr withdraw domain domain-id vsan vsan-id
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines When you enable the ivr virtual-fcdomain-add command, links may fail to come up due to overlapping
virtual domain identifiers. If so, temporarily withdraw the overlapping virtual domain from that VSAN
using the ivr withdraw domain command in EXEC mode.
Examples The following command withdraws overlapping domains.
switch# ivr withdraw domain 10 vsan 20
Related Commands
domain-id Specifies the domain id. The range is 1 to 239.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
1.3(4) This command was introduced.
Command Description
show ivr virtual-fcdomain-add-status Displays the configured VSAN topology for a fabric.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available