Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-110
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
islb zoneset activate
islb zoneset activate
To activate iSCSI server load balancing (iSLB) auto zones, use the islb zoneset activate command.
islb zoneset activate
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Auto-zoning of the initiator with the initiator targets is enabled by default.
A zone set must be active for a VSAN for auto-zones to be created in that VSAN. The zoneset activate
command creates auto-zones only if at least one other change has been made to the zone set.
Examples The following example activates an iSLB auto zone.
switch# config t
switch(config)# islb zoneset activate
Related Commands
Release Modification
3.0(1) This command was introduced.
Command Description
show zoneset active Displays active zone sets.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available