Send documentation comments to mdsfeedback-doc@cisco.com
27-9
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone convert zone
zone convert zone
To convert the zone member type from one type to another, use the zone convert zone command in the
configuration mode.
zone convert zoneset name source-member-type dest-member-type vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines To use this command, all members have to be logged in. The conversion will fail even if a single member
conversion is not achieved.
Table 27-1 describes the conversion matrix of the member types supported by this command.
name Displays the name of the zone or zoneset. All members of the specified zone
or zoneset will be converted to the new type.
source-member-type Displays the member type of the members that have to be converted. The
values of the supported source member types include fWWN, pWWN,
Device-Alias, FCID, Interface and Interface-Domain.
dest-member-type Displays the member type of the destination member. The values of the
supported destination member types include fWWN, pWWN, Device-Alias,
FCID, Interface, and Interface-Domain.
vsan vsan-id Displays the VSAN ID.
Release Modification
3.2(1) This command was introduced.
Table 27-1 Conversion Matrix of the Member Types
Source Member Types Supported Destination Member Types
fWWN pWWN, FCID, Device-alias, Interface, Interface-Domain
Interface pWWN, FCID, Device-alias, Interface, Interface-Domain
Interface-Domain pWWN, FCID, Device-alias, Interface
pWWN FCID, Device-Alias
FCID pWWN, Device-Alias
Device-Alias FCID, pWWN
To Next Page
Loading...
Need help?
General
