EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #742 background imageLoading...
Page #742 background image
Send documentation comments to mdsfeedback-doc@cisco.com
15-12
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
member (zoneset configuration submode)
member (zoneset configuration submode)
To configure zone set zone members, use the member command in zone set configuration submode. To
remove a zone set member, use the no form of the command.
member member-name
no member member-name
Syntax Description
Defaults None.
Command Modes Zone set configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to add a member zone to a zone set.
switch# config terminal
switch(config)# zoneset name Zoneset1 vsan 10
switch(config-zoneset)# member ZoneA
Related Commands
member-name Specifies the member name. Maximum length is 64 characters.
Release Modification
1.0(2) This command was introduced.
Command Description
show zone Displays zone information.
zoneset name Creates a zone set.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals