Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
22-144
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ip traffic
show ip traffic
To display IP protocol statistics for the system, use the show ip traffic command.
show ip traffic [interface gigabitethernet slot/port]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays IP protocol statistics for the Gigabit Ethernet interface.
switch# show ip traffic interface gigabitethernet 2/2
IP Statistics for GigabitEthernet2/2
Rcvd: 0 total, 0 local destination
0 errors, 0 unknown protocol, 0 dropped
Sent: 30 total, 0 forwarded 0 dropped
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
0 fragmented, 0 fragments created, 0 couldn't fragment
ICMP Statistics:
Rcvd: 0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
Sent: 0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
Related Commands
interface Displays the IP neighbors for a specified interface.
gigabitethernet slot/port Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
Release Modification
3.0(1) This command was introduced.
Command Description
show ip arp Displays IP neighbors for the system.
show ip interface Displays IP interface status and configuration information.