Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
2-15
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
arp
arp
To enable the Address Resolution Protocol (ARP) for the switch, use the arp command.To disable ARP
for the switch, use the no form of the command.
arp hostname
no arp hostname
Syntax Description
Defaults Enabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example disables the Address Resolution Protocol configured for the host with the IP
address 10.1.1.1.
switch(config)# no arp 10.1.1.1
switch(config)#
Related Commands
hostname Specifies the name of the host. Maximum length is 20 characters.
Release Modification
1.0(2) This command was introduced.
Command Description
show arp Displays the ARP table.
clear arp Deletes a specific entry or all entries from the ARP table.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available