Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-85
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi enable module
iscsi enable module
To enable iSCSI features for each IPS linecard to create corresponding iSCSI interfaces, use the iscsi
enable module command.
iscsi enable module module-num
Syntax Description
Defaults iSCSI interfaces are disabled on IPS linecards by default.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to enable the iSCSI interface on a desired module number on the
switch.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# iscsi enable module 1
Note The iSCSI feature must be enabled before executing this command.
Related Commands
module-num Specifies the desired IPS linecard module number on which iSCSI interfaces
need to be enabled.
Release Modification
3.2(1) This command was introduced.
Command Description
iscsi enable Enables the iSCSI features but does not create the interfaces.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available