Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
14-22
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
logging timestamp
logging timestamp
To set the time increment for the message logging time stamp, use the logging timestamp command. To
negate the previously issued command or to revert to factory defaults, use the no form of the command.
logging timestamp {microseconds | milliseconds | seconds}
no logging timestamp {microseconds | milliseconds | seconds}
Syntax Description
Defaults Seconds.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example sets the logging time stamp to milliseconds.
switch## config terminal
switch(config)# logging timestamp milliseconds
Related Commands
microseconds Sets the logging time stamp to microseconds.
milliseconds Sets the logging time stamp to milliseconds.
seconds Sets the logging time stamp to seconds.
Release Modification
3.0(1) This command was introduced.
Command Description
show logging Displays logging configuration information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available