Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-22
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
cimserver
cimserver
Use the cimserver command to configure the Common Information Models (CIM) parameters. Use the
no form of this command to revert to factory defaults.
cimserver
{certificate {bootflash:filename | slot0:filename | volatile:filename} |
clearcertificate filename |
enable |
enablehttp |
enablehttps}
no cimserver
{certificate {bootflash:filename | slot0:filename | volatile:filename} |
clearcertificate filename
enable
enablehttp
enablehttps}
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines A CIM client is required to access the CIM server. The client can be any client that supports CIM.
certificate Installs the Secure Socket Layer (SSL) certificate
bootflash: Specifies the location for internal bootflash memory.
slot0: Specifies the location for the CompactFlash memory or PCMCIA card.
volatile: Specifies the location for the volatile file system.
filename The name of the license file with a .pem extension.
clearcertificate Clears a previously-installed SSL certificate.
enable Enables and starts the CIM server.
enablehttp Enables the HTTP (non-secure) protocol for the CIM server—(default).
enablehttps Enables the HTTPS (secure) protocol for the CIM server.
Release Modification
1.3(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available