Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
20-10
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
radius-server retransmit
radius-server retransmit
To globally specify the number of times the switch should try a request with a RADIUS server, use the
radius-server retransmit command. To revert to default value, use the no form of the command.
radius-server retransmit count
no radius-server retransmit count
Syntax Description
Defaults 1 retransmission
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures the number of retransmissions to 3.
switch# config terminal
switch(config)# radius-server retransmit 3
Related Commands
count Configures the number of times the switch tries to connect to a RADIUS
server(s) before reverting to local authentication. The range is 1 to 5 times.
Release Modification
1.0(2) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available