Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-72
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
switchport ingress-rate
switchport ingress-rate
To configure the port rate limit for a specified interface, use the switchport ingress-rate command in
interface configuration mode. Use the no form of the command to delete the configured switch port
information.
switchport ingress-rate limit
no switchport ingress-rate limit
Syntax Description
Defaults Disabled.
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the
switch(config-if)# submode. This command is only available if the
following conditions are true:
• The QoS feature is enabled using the qos enable command.
• The command is issued in a Cisco MDS 9100 series switch.
Examples The following example configures the ingress rate limit on a Fibre Channel interface.
switch# config terminal
switch(config)# interface fc 2/5
switch(config-if)# switchport ingress-rate 5
Related Commands
limit Specifies the ingress rate limit as a percentage. The range is 1 to 100.
Release Modification
1.3(1) This command was introduced.
Command Description
show interface fc Displays an interface configuration for a specified Fibre Channel interface.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available