Send documentation comments to mdsfeedback-doc@cisco.com
11-18
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
install module loader
install module loader
To upgrade the bootloader on either the active or standby supervisor module, use the install module
loader command. This command is only for supervisor modules, not switching modules.
install module module-number loader kickstart [bootflash: | slot0: | volatile: | kickstart-image]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Before issuing the install module loader command, be sure to read the release notes to verify
compatibility issues between the boot loader and the kickstart or system images.
If you install a loader version that is the same as the currently-installed version, the loader will not be
upgraded. When both the current version and the installed version are the same, use the init system
command to force a loader upgrade.
Examples The following example shows how to perform a non disruptive upgrade for the system.
switch# install module 6 loader bootflash:kickstart_image
This example displays the command being issued on the standby supervisor module in slot 6.
Related Commands
module-number Enters the module number for the active or standby supervisor modules (only
slot 5 or 6).
kickstart Specifies the kickstart image to use.
bootflash: Source location for internal bootflash memory
slot0: Source location for the CompactFlash memory or PCMCIA card.
volatile: Source location for the volatile file system.
kickstart-image The name of the kickstart image.
Release Modification
1.0(3) This command was introduced.
Command Description
show version Verify the output before and after the upgrade.
To Next Page
Loading...
Need help?
General
