Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-142
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ip route
show ip route
To display the ip routes currently active, use the show ip route command.
show ip route [configured]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays active IP routes.
switch# show ip route
Codes: C - connected, S - static
Default gateway is 172.22.95.1
C 10.0.0.0/24 is directly connected, vsan1
C 172.22.95.0/24 is directly connected, mgmt0
The following example displays configured IP routes.
switch# show ip route configured
default 172.22.31.1 0.0.0.0 0 mgmt0
10.10.11.0 10.10.11.1 255.255.255.0 0 GigabitEthernet1/1
10.10.50.0 10.10.50.1 255.255.255.0 0 GigabitEthernet1/2.1
10.10.51.0 10.10.51.1 255.255.255.0 0 GigabitEthernet1/2.2
10.10.60.0 10.10.60.1 255.255.255.0 0 GigabitEthernet1/2
172.22.31.0 172.22.31.110 255.255.255.0 0 mgmt0
configured Displays configured IP routes.
Release Modification
1.0(2) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available