Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-20
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone-attribute-group rename
zone-attribute-group rename
To rename a zone attribute group, use the zone-attribute-group rename command in configuration
mode.
zone attribute group rename current-name new-name vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to rename a zone attribute group.
switch# config terminal
switch(config)# zone-attribute-group rename Group1 Group2 vsan 10
Related Commands
current-name Specifies the current zone attribute name. Maximum length is 64 characters.
new-name Specifies the new zone attribute name. Maximum length is 64 characters.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.0(x) This command was introduced.
Command Description
show zone-attribute-group Displays zone attribute group information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available