Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-20
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
server (radius configuration)
server (radius configuration)
To configure a RADIUS server, use the server command in RADIUS configuration submode. To discard
the configuration, use the no form of the command.
server [ipv4-address | ipv6-address | dns-name]
no server [ipv4-address | ipv6-address | dns-name]
Syntax Description
Defaults None.
Command Modes RADIUS configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows the server command in RADIUS configuration submode.
switch# config terminal
switch(config)# aaa group server radius testgroup
switch(config-radius)# server myserver
Related Commands
ipv4-address Specifies the RADIUS server IP address in the format A.B.C.D.
ipv6-address Specifies the RADIUS server IP address in the format X:X::X.
name Specifies the RADIUS DNS server name. The maximum size is 255.
Release Modification
1.3(1) This command was introduced.
3.0(1) Added the ipv6-address argument.
Command Description
radius-server host Configures RADIUS server parameters.
show radius-server Displays RADIUS server configuration parameters.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available