Send documentation comments to mdsfeedback-doc@cisco.com
11-91
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi interface vsan-membership
iscsi interface vsan-membership
To configure VSAN membership for iSCSI interfaces, use the iscsi interface vsan-membership
command. Use the no form of this command to disable this feature or to revert to factory defaults.
iscsi interface vsan-membership
no iscsi interface vsan-membership
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines If the iscsi interface vsan-membership command is disabled, you will not be able to configure iSCSI
VSAN membership.
Caution Changing the VSAN membership, the forwarding mode, and the authentication of an iSCSI interface that
is part of an iSLB VRRP group impacts load balancing on the interface.
For additional information, refer to the “Configuring iSCSI” chapter of the Cisco MDS 9000 Family CLI
Configuration Guide.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following command enables the iSCSI interface VSAN membership.
switch# config terminal
switch(config)# iscsi interface vsan-membership
The following command disables the iSCSI interface VSAN membership (default).
switch(config)# no iscsi interface vsan-membership
Release Modification
1.3(1) This command was introduced.
To Next Page
Loading...
Need help?
General
