Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-11
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone merge-control restrict vsan
zone merge-control restrict vsan
To restrict zone database merging, use the zone merge-control restrict vsan command in configuration
mode. To disable this feature, use the no form of the command.
zone merge-control restrict vsan vsan-id
no zone merge-control restrict vsan vsan-id
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines If merge control setting is restricted and the two databases are not identical, the ISLs between the switches
are isolated.
Examples The following example shows how to configure zone merge control.
switch# config terminal
switch(config)# zone merge-control restrict vsan 10
Related Commands
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
2.0(x) This command was introduced.
Command Description
show zone Displays zone information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available