Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
23-12
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
tacacs-server timeout
tacacs-server timeout
To specify the time between retransmissions to the TACACS+ servers, use the tacacs-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
tacacs-server timeout seconds
notacacs-server timeout seconds
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines This command is only available when the TACACS+ feature is enabled using the tacacs+ enable
command.
Examples The following example configures the TACACS+ server timeout value.
switch# config terminal
switch(config)# tacacs-server timeout 30
Related Commands
seconds Specifies the time (in seconds) between retransmissions to the RADIUS
server. The default is one (1) second and the valid range is 1 to 60 seconds.
Release Modification
1.3(2) This command was introduced.
Command Description
show tacacs-server Displays TACACS+ server information.
tacacs+ enable Enable TACACS+.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available