EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #259 background imageLoading...
Page #259 background image
Send documentation comments to mdsfeedback-doc@cisco.com
4-121
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
crypto ike domain ipsec rekey sa
crypto ike domain ipsec rekey sa
To rekey an IKE crypto security association (SA) in the IPsec domain, use the crypto ike domain ipsec
rekey sa command.
crypto ike domain ipsec rekey sa sa-index
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, IKE must be enabled using the crypto ike enable command.
Note This command is not supported on the Cisco MDS 9124 switch.
Examples The following example rekeys an IKE crypto SA.
switch# crypto ike domain ipsec rekey sa 100
Related Commands
sa-index Specifies the SA index. The range is 1 to 2147483647.
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ike enable Enables the IKE protocol.
show crypto ike domain ipsec Displays IKE information for the IPsec domain.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals