Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-83
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear vrrp
clear vrrp
To clear all the software counters for the specified virtual router, use the clear vrrp command in EXEC
mode.
clear vrrp {statistics [ipv4 | ipv6] vr number interface {gigabitethernet slot/port | mgmt 0 |
port-channel portchannel-id | vsan vsan-id}}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows how to clear all the software counters for virtual router 7 on VSAN 2.
switch# clear vrrp vr 7 interface vsan2
Related Commands
statistics Clears global VRRP statistics.
ipv4 Clears IPv4 virtual router statistics.
ipv6 Clears IPv6 virtual router statistics.
vr number Clears specific virtual router statistics and specifies a VR number from 1 to
255.
interface Clears an interface.
gigabitethernet
slot/port
Clears a specified Gigabit Ethernet interface.
mgmt 0 Specifies the management interface.
port-channel
port-channel-number
Clears a specified PortChannel interface.The ID of the PortChannel
interface is from 1 to 128.
vsan vsan-id Clears a specified VSAN. The ID of the VSAN is from 1 to 4093.
Release Modification
1.0(2) This command was introduced.
3.0(1) Added the ipv4 and ipv6 arguments.
Command Description
show vrrp Displays VRRP configuration information.
vrrp Enables VRRP.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available