Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-105
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
copy ssm-nvram standby-sup
copy ssm-nvram standby-sup
To copy the contents of the Storage Services Module (SSM) NVRAM to the standby Supervisor 2
module when migrating from a Supervisor 1 to Supervisor 2 module, use the copy ssm-nvram
standby-sup command in EXEC mode.
copy ssm-nvram standby-sup
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command should only be used for migrating from a Supervisor 1 to a Supervisor 2 module. When
both modules in the switch are the same, you should not use this command; use the copy command
instead.
Examples The following example copies the contents of the SSM NVRAM to the standby Supervisor 2 module.
switch# copy ssm-nvram standby-sup
Related Commands
Release Modification
3.0(1) This command was introduced.
Command Description
copy Saves a backup of the system software.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available