Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-98
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
commit
commit
To apply the pending configuration pertaining to the Call Home configuration session in progress, use
the commit command in Call Home configuration submode.
commit
Syntax Description This command has no other arguments or keywords.
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines CFS distribution must be enabled before you can commit the Call Home configuration.
Examples The following example shows how to commit the Call Home configuration commands.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# commit
Related Commands
Release Modification
1.3(1) This command was introduced.
Release Modification
2.0(1b) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available