Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-94
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system health module
system health module
To configure Online Health Management System (OHMS) features for a specified module, use the
system health module command. To disable these features, use the no form of this command.
system health module slot
[battery-charger [failure-action | frequency seconds] |
bootflash [failure-action | frequency seconds] |
cache-disk [failure-action | frequency seconds] |
cf-crc-check [failure-action | frequency frequency] |
cf-re-flash [failure-action | frequency frequency] |
eobc [failure-action | frequency seconds] |
failure-action |
inband [failure-action | frequency seconds] |
loopback [failure-action] |
mgmt [failure-action | frequency seconds]]
no system health module slot
[battery-charger [failure-action | frequency seconds] |
bootflash [failure-action | frequency seconds] |
cache-disk [failure-action | frequency seconds] |
cf-crc-check [
failure-action | frequency frequency] |
cf-re-flash [failure-action | frequency frequency] |
eobc [failure-action | frequency seconds] |
failure-action |
inband [failure-action | frequency seconds] |
loopback [failure-action] |
mgmt [failure-action | frequency seconds]]
Syntax Description module slot Specifies the module slot number.
battery-charger Configures the battery-charger test on the specified module.
frequency seconds Specifies the frequency in seconds. The range for the bootflash
frequency option is 10 to 255. The range for the cf-crc-check frequency
option is 1 to 30. The range for the cf-re-flash frequency option is 30 to
90. For all other options, the range is 5 to 255.
failure-action Controls the software from taking any action if a CompactFlash failure is
determined while running the CRC checksum test.
bootflash Configures the bootflash test on the specified module.
cache-disk Configures the cache-disk test on the specified module.
cf-crc-check Configures the CRC checksum test.
cf-re-flash Configures the firmware update.
eobc Configures the EOBC test on the specified module.
inband Configures the inband test on the specified module.
loopback Configures the loopback test on the specified module.
mgmt Configures the management port test on the specified module.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available