Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
7-2
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 7 E Commands
email-contact
email-contact
To configure an e-mail contact with the Call Home function, use the email-addr command in Call Home
configuration submode. To disable this feature, use the no form of the command.
email-addr email-address
no email-addr email-address
Syntax Description
Defaults None.
Command Modes Call Home configuration submode
Command History
Usage Guidelines None.
Examples The following example shows how to configure e-mail contact in the Call Home configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# email-contact username@company.com
Related Commands
email-address Configures an e-mail address. Uses a standard e-mail address that does not
have any text size restrictions.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available