Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-287
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show san-ext-tuner
show san-ext-tuner
To display SAN extension tuner information, use the show san-ext-tuner command.
show san-ext-tuner {interface gigabitethernet slot/port [nport pwwn pwwn-id vsan vsan-id
counters] | nports}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows how to display SAN extension tuner N port information.
switch# show san-ext-tuner nports
Related Commands
interface Displays SAN extension tuner information for a specific Gigabit Ethernet
interface.
gigabitethernet
slot/port
Specifies a Gigabit Ethernet interface.
nport Specifies an N port.
pwwn pwwn-id Specifies a pWWN ID. The format is hh:hh:hh:hh:hh:hh:hh:hh, where h is
a hexadecimal number.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
counters Specifies SAN extension tuner counters.
nports Displays SAN extension tuner information for all nports.
Release Modification
2.0(x) This command was introduced.
Command Description
san-ext-tuner Enters SAN extension tuner configuration mode.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available