Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-4
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fabric-binding database copy
fabric-binding database copy
To copy from the active fabric binding database to the configuration fabric binding database, use the
fabric-binding database copy command in EXEC mode.
fabric-binding database copy vsan vsan-id
Syntax Description
Defaults None
Command Modes EXEC mode
Command History
Usage Guidelines Fabric binding is configured on a per-VSAN basis and can be implemented in both FICON VSANs and
Fibre Channel VSANs.
If the configured database is empty, this command is not accepted
Examples The following example copies from the active database to the config database in VSAN 1.
switch# fabric-binding database copy vsan 1
Related Commands
vsan vsan-id Specifies the VSAN. The ID of the VSAN is from 1 to 4093.
Release Modification
1.3(1) This command was introduced.
3.0(1) Extended support for fabric binding to Fibre Channel VSANs.
Command Description
fabric-binding diff Provides the differences between the fabric-binding databases.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available