Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-161
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ipv6 neighbours
show ipv6 neighbours
To display IPv6 neighbors configuration information, use the show ipv6 neighbours command.
show ipv6 neighbours [interface {gigabitethernet slot/port | mgmt 0 | vsan vsan-id}]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays information about IPv6 neighbor discovery.
switch# show ipv6 neighbours gigabitethernet 2/1
IPv6 Address Age Link-layer Addr State Interface
2001:0DB8:0:4::2 0 0003.a0d6.141e REACH Ethernet2
FE80::XXXX:A0FF:FED6:141E 0 0003.a0d6.141e REACH Ethernet2
2001:0DB8:1::45a - 0002.7d1a.9472 REACH Ethernet2
Related Commands
interface Displays the IP interface status and configuration.
gigabitethernet
slot/port
Displays a Gigabit Ethernet interface slot and port number.
mgmt 0 Displays the management interface.
vsan vsan-id Displays an IPFC VSAN interface and specifies the VSAN ID. The range is
1 to 4093
Release Modification
3.1(0) This command was introduced.
Command Description
ipv6 nd Configures IPv6 neighbor discovery commands.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available