Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-16
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone name (zone set configuration submode)
zone name (zone set configuration submode)
To configure a zone in a zone set, use the zone name command in zone set configuration submode. To
delete the zone from the zone set, use the no form of the command.
zone name zone-name
no zone name zone-name
Syntax Description
Defaults None.
Command Modes Zone set configuration mode.
Command History
Usage Guidelines None.
Examples The following example configure a zone in a zone set.
switch# config terminal
switch(config)# zoneset name Sample vsan 1
switch(config-zoneset)# zone name MyZone
The following example deletes a zone from a zone set.
switch(config-zoneset)# no zone name Zone2
Related Commands
zone-name Specifies the name of the zone. Maximum length is 64 characters.
Release Modification
1.0(2) This command was modified.
Command Description
show zoneset Displays zone set information.
zone name
(configuration mode)
Configure zones.
zoneset Configures zone set attributes.

Cisco MDS 9000 Series Specifications

General

Brand	Cisco
Model	MDS 9000 Series
Category	Switch
Language	English