Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-181
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show islb pending
show islb pending
To display iSCSI server load balancing (iSLB) pending configurations, use the show islb pending
command.
show islb pending
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows iSLB pending configuration information.
switch# show islb pending
iscsi initiator idle-timeout 10
islb initiator ip-address 10.1.1.1
static pWWN 23:01:00:0c:85:90:3e:82
static pWWN 23:06:00:0c:85:90:3e:82
username test1
islb initiator ip-address 10.1.1.2
static nWWN 23:02:00:0c:85:90:3e:82
Related Commands
Release Modification
3.0(1) This command was introduced.
Command Description
show islb initiator Displays iSLB initiator information.
show islb cfs-session
status
Displays iSLB session information.
show islb merge status Displays iSLB merge status information.
show islb pending-diff Displays iSLB pending configuration differences.
show islb session Displays iSLB session information.
show islb status Displays iSLB CFS status information.
show islb virtual-target Displays iSLB virtual target information.
show islb vrrp Display iSLB VRRP load balancing information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available