Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-145
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ips arp
show ips arp
To display the IP storage ARP cache information, use the show ips arp command.
show ips arp interface gigabitethernet slot/port
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Use the show ips arp interface gigabitethernet command to display the ARP cache on the Gigabit
Ethernet interfaces. This command takes the main Ethernet interface and as a parameter and returns the
ARP cache for that interface.
Examples The following example displays ARP caches in the specified interface.
switch# show ips arp interface gigabitethernet 4/1
Protocol Address Age (min) Hardware Addr Type Interface
Protocol Address Age (min) Hardware Addr Type Interface
Internet 172.22.91.1 2 - 00:00:0c:07:ac:01 ARPA GigabitEthernet4/4
Internet 172.22.91.2 0 - 00:02:7e:6b:a8:08 ARPA GigabitEthernet4/4
Internet 172.22.91.17 0 - 00:e0:81:20:45:f5 ARPA GigabitEthernet4/4
Internet 172.22.91.18 0 - 00:e0:81:05:f7:64 ARPA GigabitEthernet4/4
Internet 172.22.91.30 0 - 00:e0:18:2e:9d:19 ARPA GigabitEthernet4/4
...
interface gigabitethernet slot/port Specifies a Gigabit Ethernet interface by the slot and port.
Release Modification
1.1(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available