Send documentation comments to mdsfeedback-doc@cisco.com
22-188
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show islb vrrp
show islb vrrp
To display iSLB VRRP load balancing information, use the show islb vrrp command.
show islb vrrp [assignment [initiator node-name [vr group-number] | vr group-number] |
interface [switch WWN [vr group-number] | vr group-number] | summary [vr group-number]
| vr group-number]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows iSLB VRRP interface information.
switch# show islb vrrp interface vr 41
-- Interfaces For Load Balance --
Interface GigabitEthernet1/1.441
Switch wwn: 20:00:00:0d:ec:02:cb:00
VRRP group id: 41, VRRP IP address: 10.10.122.112
Interface VRRP state: backup
Interface load: 3000
Interface redirection: enabled
Group redirection: enabled
Number of physical IP address: 1
(1) 10.10.122.115
Port vsan: 1
Forwarding mode: store-and-forward
Proxy initiator mode: disabled
iSCSI authentication: CHAP or None
assignment Displays iSLB VRRP initiator to interface assignment.
initiator node-name Displays a specific iSLB initiator’s interface assignment. The maximum is
80.
vr group-number Displays information for a specific VR group. The range is 1 to 255.
interface Displays iSLB VRRP interface information.
switch WWN Displays a interface information for a specific switch. The format of WWN
is hh:hh:hh:hh:hh:hh:hh:hh.
summary Displays iSLB VRRP load balancing summary information.
Release Modification
3.0(1) This command was introduced.
To Next Page
Loading...
Need help?
General
