Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-187
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show islb virtual-target
Trespass support is disabled
Revert to primary support is disabled
target: newtarget0987654321
Configured node (iSLB)
No. of initiators permitted: 1
initiator fromtarget1234567890 is permitted
All initiator permit is enabled
Trespass support is disabled
Revert to primary support is disabled
target: mytargetdevice123
Configured node (iSLB)
All initiator permit is disabled
Trespass support is enabled
Revert to primary support is disabled
Related Commands Command Description
show islb cfs-session
status
Displays iSLB session information.
show islb initiator Displays iSLB initiator information.
show islb merge status Displays iSLB merge status information.
show islb pending Displays iSLB pending configurations.
show islb pending-diff Displays iSLB CFS pending configuration differences.
show islb session Displays iSLB session information.
show islb status Displays iSLB CFS status information.
show islb vrrp Display iSLB VRRP load balancing information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available