Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-101
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug rlir
debug rlir
To enable Registered Link Incident Report (RLIR) debugging, use the debug rlir command in EXEC
mode. To disable a debug command, use the no form of the command or use the no debug all command
to turn off all debugging.
debug rlir {all | errors | events | mts-errors | mts-events}
no debug rlir {all | errors | events | mts-errors | mts-events}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug rlir all command is issued:
switch# debug rlir all
Related Commands
all Enables debugging for all RLIR features.
errors Enables debugging for RLIR error conditions.
events Enables debugging for the RLIR events.
mts-errors Enables debugging for MTS error conditions.
mts-events Enables debugging for MTS events.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
show rlir Displays information about RLIR, Link Incident Record Registration
(LIRR), and Distribute Registered Link Incident Record (DRLIR) frames.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available