Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
18-12
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
policy
policy
To enter IKE policy configuration and configure a policy for the IKE protocol, use the policy command
in IKE configuration submode. To delete the policy, use the no form of the command.
policy priority
no policy priority
Syntax Description
Defaults None.
Command Modes IKE configuration submode.
Command History
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how to configure a policy priority number for the IKE protocol.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)#
Related Commands
priority Specifies the priority for the IKE policy. The range is 1 to 255, where 1 is the
high priority and 255 is the lowest.
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ike domain ipsec Enters IKE configuration mode.
crypto ike enable Enables the IKE protocol.
show crypto ike domain ipsec Displays IKE information for the IPsec domain.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available