Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
27-4
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands
zone commit vsan
zone commit vsan
To commit zoning changes to a VSAN, use the zone commit vsan command in configuration mode. To
negate the command, use the no form of the command.
zone commit vsan vsan-id [force]
no zone commit vsan vsan-id [force]
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines Use the no form of the zone commit vsan command to clear a session lock on a switch where the lock
originated.
Examples The following example commits zoning changes to VSAN 200.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# zone commit vsan 200
Related Commands
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
force Forces the commit.
Release Modification
2.0(1a) This command was introduced.
Command Description
show zone Displays zone information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available