Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-37
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface vsan
interface vsan
To configure a VSAN interface, use the interface vsan command. To remove a VSAN interface, use the
no form of the command.
interface vsan vsan-id
no interface vsan vsan-id
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example selects a VSAN interface and enters interface configuration submode.
switch# config terminal
switch(config)# interface vsan 1
switch(config-if)#
Related Commands
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
1.0(2) This command was introduced.
Command Description
show interface Displays interface configuration for specified interface.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available