Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-50
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
ssh server enable
ssh server enable
To enable the SSH server, use the ssh server enable command in configuration mode. To disable the
SSH service, use the no form of the command.
ssh server enable
no ssh server enable
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example enables the SSH server.
switch# config terminal
switch(config)# ssh server enable
updated
The following example disables the SSH server.
switch# config terminal
switch(config)# no ssh server enable
updated
Related Commands
Release Modification
1.0(2) This command was introduced.
Command Description
show ssh server Displays SSH server information.
ssh key Generates an SSH key.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available