Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-120
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
crypto ike domain ipsec
crypto ike domain ipsec
To enter IKE configuration submode, use the crypto ike domain ipsec command.
crypto ike domain ipsec
Syntax Description This command has no other arguments or keywords.
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines To configure IKE protocol attributes, IKE must be enabled using the crypto ike enable command.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example shows how enter IKE configuration mode.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)#
Related Commands
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ike enable Enables the IKE protocol.
show crypto ike domain ipsec Displays IKE information for the IPsec domain.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available