Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-159
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show ipv6 interface
show ipv6 interface
To display IPv6 interface status and configuration information, use the show ipv6 interface command.
show ipv6 interface [gigabitethernet slot/port | mgmt 0 | port-channel port-channel-number |
vsan vsan-id]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displaysIPv6 interface information.
switch# show ipv6 interface
GigabitEthernet1/2 is up
IPv6 is enabled
Global address(es):
5000::1/64
Link-local address(es):
fe80::205:30ff:fe01:a6bf
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
Stateless autoconfig for addresses disabled
GigabitEthernet2/2 is up
IPv6 is enabled
Global address(es):
6000::1/64
Link-local address(es):
fe80::205:30ff:fe00:a413
ND DAD is disabled
gigabitethernet
slot/port
Displays a Gigabit Ethernet interface.
mgmt 0 Displays the management interface.
port-channel Displays a PortChannel interface.
port-channel-number Specifies the PortChannel number. The range is 1 to 128.
vsan Displays an IPFC VSAN interface.
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
3.1(0) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available