Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
20-11
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
radius-server timeout
radius-server timeout
To specify the time between retransmissions to the RADIUS servers, use the radius-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
radius-server timeout seconds
no radius-server timeout seconds
Syntax Description
Defaults 1 second
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures the timeout value to 30 seconds.
switch# config terminal
switch(config)# radius-server timeout 30
Related Commands
seconds Specifies the time (in seconds) between retransmissions to the RADIUS
server. The range is 1 to 60 seconds.
Release Modification
1.0(2) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available