Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-120
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug tcap
debug tcap
To enable debugging the exception logger, use the debug tcap command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug tcap {demux | deque | error | info | init}
no debug tcap {demux | deque | error | info | init}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines Use this command to debug terminal capture utility events and information.
Examples The following example displays the system output when the debug tcap demux command is issued:
switch# debug tcap demux
Related Commands
demux Enables debugging for terminal capture demux functions.
deque Enables debugging for terminal capture deque events.
error Enables debugging for terminal capture errors.
info Enables debugging for terminal capture information.
init Enables debugging for terminal capture initialization.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available