Send documentation comments to mdsfeedback-doc@cisco.com
22-126
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show install all status
show install all status
To display the on-going install all command status or the log of the last installed install all command
from a Console, SSH, or Telnet session, use the show install all status command.
show install all status
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command only displays the status of an install all command that is issued from the CLI, not the
Fabric Manager.
The show install all status command also displays the status of nondisruptive software upgrades on the
Cisco MDS 9124 Fabric Switch (after the switch has rebooted and comes up with the new image).
Actions that occurred before the reboot are not displayed in the output. So, if you issue the install all
command via a telnet session, the telnet session will be disconnected when the switch reboots. After you
reconnect to the switch using telnet, the upgrade may already be complete; in this case, the show install
all status command will display the status of the upgrade.
Examples Use the show install all status command to view the output of a install all command process.
switch# show install all status
There is an on-going installation... <---------------------- in progress installation
Enter Ctrl-C to go back to the prompt.
Verifying image bootflash:/b-1.3.0.104
-- SUCCESS
Verifying image bootflash:/i-1.3.0.104
-- SUCCESS
Extracting “system” version from image bootflash:/i-1.3.0.104.
-- SUCCESS
Extracting “kickstart” version from image bootflash:/b-1.3.0.104.
-- SUCCESS
Release Modification
1.3(1) This command was introduced.
To Next Page
Loading...
Need help?
General
