Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-207
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show kernel core
show kernel core
To display kernel core configuration information, use the show kernel core command.
show kernel core {limit | module slot | target}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following examples display kernel core settings.
switch# show kernel core limit
2
switch# show kernel core target
10.50.5.5
switch# show kernel core module 5
module 5 core is enabled
level is header
dst_ip is 10.50.5.5
src_port is 6671
dst_port is 6666
dump_dev_name is eth1
dst_mac_addr is 00:00:0C:07:AC:01
limit Displays the configured line card limit.
module slot Displays the kernel core configuration for a module in the specified slot.
target Displays the configured target IP address.
Release Modification
1.1(1) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available