Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-81
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show fc-redirect peer-switches
show fc-redirect peer-switches
To display all the peer switches in the fabric running FC- Redirect, use the show fc-redirect
peer-switches command.
show fc-redirect peer-switches
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This command is used to verify the fabric state and is used for troubleshooting.
Note To find the switch IP address for the list of switch WWN(s), use the show cfs peers command.
Examples The following example displays the peer switches in the fabric running FC-Redirect
switch# show fc-redirect peer-switches
------------------------------------------------
num Switch WWN State
------------------------------------------------
1 20:00:00:05:30:00:90:9e UP
2 21:00:00:05:30:00:90:9f DOWN
3 22:00:00:05:30:00:90:91 SYNCING
4 23:00:00:05:30:00:90:92 ERROR
Table 22-3 describes the output for the show fc-redirect peer-switches states.
This command has no other arguments or keywords.
Release Modification
3.2(1) This command was introduced.
Table 22-3 Show FC-Redirect Peer Switch States
State Description
Up The peer switch is fully synchronized with the
local switch.
Down The communication with the peer switch is not
available.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available