Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-15
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
sdv enable
sdv enable
To enable SDV on the switch, use the sdv enable command in configuration mode. To disable SDV, use
the no form of the command.
sdv enable
no sdv enable
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to enable SDV.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv enable
The following example shows how to disable SDV.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# no sdv enable
Related Commands
Release Modification
3.1(2) This command was introduced.
Command Description
show sdv database Displays the SDV database.
show vritual-device Displays the virtual devices.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available