Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-49
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcsp enable
fcsp enable
To enable the Fibre Channel Security Protocol (FC-SP) in a switch, use the fcsp enable command in
configuration mode. Further FC-SP commands are available when the FC-SP feature is enabled. To
disable FC-SP, use the no form of the command.
fcsp enable
no fcsp enable
Syntax Descriptionf
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example enables FC-SP.
switch# config terminal
switch(config)# fcsp enable
switch(config)#
Related Commands
fcsp Specifies the FC-SP feature in the switch.
enable Enables the FC-SP feature in this switch.
Release Modification
1.3(1) This command was introduced.
Command Description
show fcsp Displays configured FC-SP information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available